That is to say, the files on the NTFS drive can be viewed and moved out but they cannot be deleted, renamed, modified or converted. However, they find a Windows NTFS-formatted external hard disk read-only after they move to a Mac. However, some Windows users will format it to NTFS later. Then reboot your Mac normally again.When a new external hard drive from Seagate, Western Digital, Toshiba or Samsung is purchased, most of time it is initially formatted with FAT file system. In the recovery console, open the terminal window and re-enable the system integrity using following command: csrutil enable Last but not least, you need to re-enable the system integrity protection again! Reboot your Mac into the recovery console by holding Command+R while rebooting. Now the most important part - we need to replace the exisitng NTFS driver as follows: sudo mv /sbin/mount_ntfs /sbin/mount_ntfs.original sudo ln -s /usr/local/sbin/mount_ntfs /sbin/mount_ntfsĥ. Then link ntfs-3g with this command: brew link ntfs-3gĤ. No worries, you are in the right track! To fix that let’s create the required directory with this command in the Terminal: sudo mkdir sbinĮnable write permission in sbin directory using: sudo chown -R $(whoami) $(brew -prefix) But ntfs-3g installation may provide following error in your terminal: Error: Could not symlink sbin/ntfs-3g usr/local/sbin is not writable. If you don’t see any error / warnings you can just proceed to Step-4 skipping the rest of this step. Then install ntfs-3g: brew install ntfs-3gģ. Install osxfuse using homebrew with following command in your Terminal: brew cask install osxfuse In your Terminal then we are good to go for the next steps:Ģ. System Integrity Protection status: disabled. Open the Terminal to check if the system integrity status is disabled using this command: csrutil status Now reboot your Mac again and and let it boot normally. Open up the Terminal from the “Utilities” menu and type in the following: csrutil disable Reboot the Mac and hold Command+R at boot to get into the recovery console. We need to disable the system integrity protection first. You can install Homebrew pasting following command in your Terminal: /usr/bin/ruby -e '$(curl -fsSL )' Stepsġ. Enable NTFS write support in MacOS High Sierra (10.13.x) Prerequisiteīefore you begin, make sure Homebrew is installed on your current system.

Write to ntfs on mac os sierra